Ableton Announces Four New Premium Max for Live Devices Including Video FX
Tune-In to SciFi Electronica Show #2 Sunday Oct.13th at 3pm MDT (21:00 GMT)

How to Use ElectraX Synth with Ableton Push Pad Pressure and Use Ribbon Controller Like a Mod Wheel

push electrax

I finally got my hands on a Push. I’m going through songs in my existing live show and tweaking synths to be even more expressive with Push’s aftertouch and ribbon controller. In this post I’ll be focusing on the wonderful ElectraX synth by Tone2 Audiosoftware but the same concepts apply to any synthesizer that allows for CC mapping in their Mod Matrix - including all the other Tone2 synths.

The image below (click to enlarge) illustrates how to map Push’s pad pressure (aftertouch) and ribbon controller in the mod matrix.


Ribbon Controller

If you are using Ableton instruments, the ribbon controller on Push is hard wired to pitch wheel. One advantage to using third party synths is synths like ElectraX, Absynth, and others allow you to map MIDI controller information right into their mod matrix. In other words you can map the ribbon to anything you like

In ElectraX if you want to disable mod wheel so it doesn’t change pitch got to Settings and set “Pitchwheel” to off. Now go into the Mod Matrix and map Pitchwheel. In the example above, I’m using the ribbon to crossfade oscillator 1 and oscillator 2 volumes.


To map pad pressure, which is really exposed as aftertouch, go to the Mod Matrix and map “Afterto.” to parameters. In the example above I’m using pressure to close the filter and increase filter resonance.

Keep Up with Push Posts

I’ll be doing many more posts on Push in the future so keep an eye on this category You can subscribe to the RSS feed for this category here The ElextraX category is here |

Mark Mosher